Koralia Sureflow mod...

[Trigger Man]

I think now that you have shown the rest of us the light more will do it. I know I'm going to do it on atleast a couple of my K4's, I just figure I should wait till boxing week to see if the mods go on sale.

[i have crabs]

i couldin make it spin the right way since the k4 prop is shaped the opposite direction than the shure flow props
it fit and turned on fine but seemed a bit louder but mabey cause i couldnt get it to work properly

[GreenSpottedPuffer]

Originally Posted by i have crabs

i couldin make it spin the right way since the k4 prop is shaped the opposite direction than the shure flow props
it fit and turned on fine but seemed a bit louder but mabey cause i couldnt get it to work properly

Once in a while mine will spin the wrong way after I shut it off and turn it on. But all I have to do is unplug it and then plug it back in. Works everytime. You can also try turning the prop one "click" the way you want it to spin and that sometimes works. I have no issues with mine. Very quiet too. No different than the original prop.

I will get video of mine. And what it does if I keep it near the surface

[Trigger Man]

Good to know, as I have my k4's on a wavemaker system switching them on and off I guess this mod would not work well on my system, as the blades would sometimes spin right but not all the time.

I have Crabs- when it was louder was it noticably louder, as well when spinning in the oppposite direction was the flow diminished?

[GreenSpottedPuffer]

Originally Posted by Trigger Man

Good to know, as I have my k4's on a wavemaker system switching them on and off I guess this mod would not work well on my system, as the blades would sometimes spin right but not all the time.

I have Crabs- when it was louder was it noticably louder, as well when spinning in the oppposite direction was the flow diminished?

Yeah I wouldn't do this with a wavemaker. Sorry I should have said that.

When mine spin wrong they suck everything back into them and flow comes ouyt the back. No flow forward. No noise either though. I have to actually look to see if they are spinning backwards or not.

[i have crabs]

i tried the plug trick and turning the propeller when i was doin it and it would turn the same way every time, the noise was louder than i would put up with but not horrible, im shure it could be better if i fooled around more than i did.

[GreenSpottedPuffer]

Originally Posted by i have crabs

i tried the plug trick and turning the propeller when i was doin it and it would turn the same way every time, the noise was louder than i would put up with but not horrible, im shure it could be better if i fooled around more than i did.

Don't know what to say...I just tried another mod kit with the K3 and it works fine. No noise and always spins the right way. Your replacing the magnet too right? Not just the prop?

With the K3 the prop just fits in the casing and is pretty awesome how much flow a little K3 puts out now!

[i have crabs]

yep shureflow magnet and prop on the k4 rod, fits in no problem just could not get it to go the right direction, tried it in a k2 but the prop hits the front just i kittle so i never pluged it in, i do have a few k4's so mabey ill try a different one