|
|
|
#11
09-09-2008, 04:49 PM
|
|||||
|
|||||
Got a picture of the scratch?
I've thought about epoxy and cyanoacrylate too but I think the end result likely won't be better because even if, say, ultra clear, it will have different refractive properties so you'll still see some artifacts. Also I sort of worry that cyanoacrylate (super glue/super glue gel) will cause that frosting effect on nearby surfaces? Or is that only if the area is not ventilated? Good luck, whatever you do!
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee! 
|
|
#12
09-09-2008, 04:53 PM
|
|||||
|
|||||
|
Ok I got to thinking. What do the windsheild repair outlets use when filling rock chips?
Found a few repair kits for windsheilds on ebay, but are sort of costly.. but .. did find some of the resin they use. Check it out: http://cgi.ebay.ca/ws/eBayISAPI.dll?...2BSI%26otn%3D2 For $30ish it might be worth a try????
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee!
|
|
#13
09-10-2008, 03:57 AM
|
|||||
|
|||||
|
Thank You!!!
__________________
Cheers Raf & Diana Our Reef Tank: http://www.facebook.com/photo.php?pi...5&id=883435639 https://www.facebook.com/pages/Aquat...es/46469801680 Our Photos: Nikon D7000 DSLR w Nikkor 2.8d 60mm micro lens amongst others
|
|
#14
09-19-2008, 09:24 PM
|
|||||
|
|||||
|
the DIY chip repair kits use a glue that is UV activatied even if you can get it to work with a UV light or direct sunlight there is a skill required...I've done o few
I would fins a chip repair dude and try to pay him off to come to your place and have a go at it if your tank is $$$.
|
Linear Mode
