|
|
|
#11
01-14-2007, 04:01 PM
|
|||||
|
|||||
buy the good rare earth magnets from Lee Valey, the use an acrylic epoxy potting mix from industreal plastics and paints.
Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive. 
|
|
#12
01-14-2007, 05:25 PM
|
||||
|
||||
|
OK I like the encasing in epoxy/putty idea, it will also make it simpler because I can add the filter clip holder (the U-shaped part that attaches the filter pipe to the suction cup) into the epoxy at the same time.
|
|
#13
01-14-2007, 07:13 PM
|
|||||
|
|||||
|
Was thinking this through a little more, you'll have to do this in 2 stages, lay a bed of epoxy on some wax paper, give it a little scuff once dry to ensure adhesion. Lay the magnet on, cover it over with epoxy.
If you bypass the scuffing part - those tiny dixie cups they hand pills out in (about 1/2" diameter) would be a perfect mold for this project. Andy
|
Linear Mode
