|
|
|
||||||||
| Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
 |
|
|
Thread Tools | Display Modes |
|
#11
08-10-2010, 07:09 AM
|
||||
|
||||
A reef tank also has higher power (ie. hotter) lights & more flow. These contribute to the evaporation. I have glass tops now on all my tanks except the main reef and that helps a lot for reducing evaporation. Some of my tanks though are fw or fowlr.
__________________
If you see it, can take care of it, better get it or put it on hold. Otherwise, it'll be gone & you'll regret it! 
|
|
#13
08-10-2010, 12:45 PM
|
|||||
|
|||||
|
I would not cheap out when it comes to an auto top off. I did and had it running right off my ro unit i flooded my house and lost a lot of stuff in my tank as i pumped about 100 gallons of freshwater into the tank while i was at work. I would recommend a tunze and have a reservoir to prevent anything like this happening.
__________________
360 gallon sps reef, 180 gal sump, bubble king supermarine 300, 4xmp40Wes, 2 x 6215 tunze waveboxes, 4 ghl mitras 360 Reef Tank
|
|
#14
08-10-2010, 02:55 PM
|
|||||
|
|||||
|
evap
Quote:
My 20 gallon loses 1.5" a day when its hot out. It is evaporating.
__________________
 My 70 Gallon build: http://www.canreef.com/vbulletin/showthread.php?t=66478 My Mandarin Paradise: http://www.canreef.com/vbulletin/showthread.php?t=72762 I wonder... does anyone care enough to read signatures if you make them really small? I would not. I would probably moan and complain, read three words and swear once or twice. But since you made it this far, please rate my builds. 
|
|
#15
08-10-2010, 03:23 PM
|
||||
|
||||
|
Quote:
I have two systems. My RO to the storage tank has a shut off of its own. The storage tank to the tank has one too. My storage tank is 5 gallons. My corals and fish won't much like the drop in salinity that 5 gallons will cause, however, it won't kill everything. I am looking to also get the RO shut off that BRS has on their site. If it sense's water (flooding) it will pinch the RO feed line shut. It also has an audible alarm.
|
|
#16
08-10-2010, 06:49 PM
|
|||||
|
|||||
|
Link to a thread with some ATO solutions, mostly DIY.
http://www.canreef.com/vbulletin/showthread.php?t=60320
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build  http://www.canreef.com/vbulletin/showthread.php?t=82206
|
|
#17
08-10-2010, 07:29 PM
|
||||
|
||||
|
I find that my sump level decreases because of my overflow get clogged. So the water level in my overflow rises. Or my water level in my display rises as the "fingers" on my overflow get clogged and doesn't flow as well, so when I clean it, the water level in my sump rises by a few inches. So you might want to check your overflow as well.
__________________
135g
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
