What is the best way to lower phosphate and nitrate level?

[Oilers]

I am setting up a small tank (28G nanocube) for my little boy. I used some of the live rocks from my DT and filled half the tank with the water from the DT and made up the rest of the water. It's been running for about a week under metal halide light for about 12h a day. I tested the water today and found the level of phosphate and nitrate to be a bit high. Phosphate is around 2 and nitrate is around 5. What can I do or add to the tank to lower those levels down to zero? Also, there are some brown algae on top of the sand bed. What should I do beside WC which I am planning to do one tomorrow? Is the algae forming because of too much light? I have no sump but do have a skimmer running. Thanks for your input.

[reefwars]

gfo reactor does miricles for small tanks, if you do a heavy water change and run gfo through a reactor it will bring both down instantly. then if you continue a small amount of gfo and with light feedings and reg water changes nitrates shouldnt be an issue(assuming your using quality liverock)

skimmer wouldnt hurt if you can workmit in:P


***edit*** you have skimmer so good

[reefwars]

brown algae is more than likely diatoms it should go away as the tank matures and water quality stays consistant with good flow

[windcoast reefs]

I would try Gfo and some carbon, but I would also reduce your lighting from 12 hours to 8. I don't think it will do anything for the levels but it will certainly help with any algae.

[Oilers]

I have reduced the hour of lighting down to 8 and also threw in some carbon. For the GFO reactor, can it be used without a sump?

[reefwars]

Originally Posted by Oilers

I have reduced the hour of lighting down to 8 and also threw in some carbon. For the GFO reactor, can it be used without a sump?

it can be ran both hob or in sump heres a pic



basically a input from a small pump like a maxijet and output with ballvalve