|
|
|
|
|
#1
02-15-2012, 12:35 AM
|
||||
|
||||
120 g tank start up advice please
I just bought this 120g tank.
I want to set it up with a sump and use the existing plumbing. The PO said that it was set up for a wavemaker and that is why there is a compartment on the end? its 5" wide and 19" deep the tank itself is 72" wide 19" deep and 19" high. is there any point in keeping this compartment or can i remove it? Any advice would be greatly appreciated. Thanks!![ATTACH]Attachment 8936[/ATTACH] Last edited by Junmity; 03-12-2012 at 02:54 AM. 
|
|
#2
02-15-2012, 04:43 AM
|
||||
|
||||
|
I be leave that box is for your over flow into the sump, I could be wrong
|
|
#4
02-15-2012, 06:48 AM
|
|||||
|
|||||
|
Very hard to see by the way the shot was taken, side shot and the side with the plumbing would definately help!
__________________
Always looking for the next best coral... 90g starphire cube/400mhRadium20k/2 XHO/2x27w UV/2x39w T5/ 3 Trulumen led strips
|
|
#5
02-15-2012, 03:36 PM
|
||||
|
||||
|
Depends on where the bulkhead fittings are for your overflow
|
|
#6
02-15-2012, 03:51 PM
|
||||
|
||||
|
Looks like two bulkhead fittings behind the plastic overflow barrier
The lower one is your drain to sump the upper one u can plumb into drain incase one gets plugged up. Have your return pump line retun water to the otherside of you tank so it flow accross.
|
Hybrid Mode
