My overflow failed today :(

[Son Of Skyline]

I just came home to see a perfectly working system, minus 4 gallons of water from my sump, and apparently 4 gallons of water in my carpet. It seems that my external overflow had failed for a short time, sending water cascading over the top of my tank, but then started working again before my sump went dry. I looked for signs of plugging from a hermit crab perhaps, but there was no evidence. All I can see is the clear trail of salt water from the top of the tank down and onto the floor. From the size of these water marks it looks like this was a pretty dramatic event. I live in an apartment and I'm just hoping no water leaked down into the unit under me.

Is there a simple way to rig up a water on the floor sensor to my return pump so that the return pump shuts off as soon as water starts to flow over the tank onto the floor? I did some searching but all I seem to read about are audible alarms and emails sent if the water sensor goes off. I just want it to cut my return if the tank starts overflowing.

Thanks!!

[Bloodasp]

The alarm can always be changed into a relay instead which cuts off the power when the sensor senses flooding on the floor. If you are not good or not comfortable of riggig stuff like this it would be good to find someone who can.

[abcha0s]

It might be easier to use a float switch to shutoff the pump in the event of a low water event in the sump. You could use an ATO system for this purpose. Most ATOs can be configured with a sensor in the reservoir to detect a low water condition and shut off the top off pump. Theres no reason why this wouldn't work with your sump and return pump.

Anyway, I'm sorry about your misfortune although I'm glad you didn't lose the tank.

- Brad

[kien]

sorry to here, but glad to hear that it wasn't a complete catastrophe. Still, not something any of us want to come home to.. I'm curious as to what type of external overflow you are using that failed? Durso, Herbie, single stand pipe, siphon?

[Coleus]

Originally Posted by abcha0s@conceptaquatics

It might be easier to use a float switch to shutoff the pump in the event of a low water event in the sump. You could use an ATO system for this purpose. Most ATOs can be configured with a sensor in the reservoir to detect a low water condition and shut off the top off pump. Theres no reason why this wouldn't work with your sump and return pump.

Anyway, I'm sorry about your misfortune although I'm glad you didn't lose the tank.

- Brad

This is a great idea if you don't have a big ATO reservoir connecting to the system directly. Else your low switch wont activate uitl the ATO reservoir is out of water.

What i do on my is that put a high float switches on both my sum and my display tank , if the water reach these levels, my pump shut off. Also have the water floor detection as well to shut off everything. Cant afford any water on my carpet or my wife will kill me


Also, about why you are getting overflow, i found that sometime if your overflow water has to travel horizontal to get to your sump, the air get into there and build it the back pressure which cause water could not drain fast enough

[emerald crab]

HOB overflow = russian rulette.

[phi delt reefer]

by external do you mean you have a HOB overflow? If so then its an accident waiting to happen.

[gobytron]

Originally Posted by phi delt reefer

by external do you mean you have a HOB overflow? If so then its an accident waiting to happen.

I agree if it depends on a pump like an aqualifter to restart siphon.
I its a utube overflow, you should not have failure for any reason.

Going on 4 years with my current DIY overflow never, ever failing.

People who say it's an accident waiting to happen are just ignorant on this subject...likely from lack of experience.

What kind of external overflow did you use?
If it happened once, it will happen again if you dont figure out why and how.