Vortech Failure

Madreefer · #1 11-23-2010, 02:15 AM

Anyone have a dry side fail on one of these units. I put a post up a while back about the noise mine was making from new. The noise has now got alot louder. It is under warranty and I am getting a new part sent to me but the noise is really ****in me off and I see there is a screw on the inner part of the dry side. Has anyone adjusted it at all? Dont want to do so unless someone else has tried with some sort of success.

globaldesigns · #2 11-23-2010, 02:47 AM

I have talked to Ecotech Marine, as I had one dry side replaced, and just last week I was again talking with them, as my second unit sometimes gets noisy also.

They said not to turn that screw on the dry side, as it is meant to be tightened from the other side. I guess under the EcoTech logo, there is something under there. At least that is what they indicated.

So I would not suggest turning it.

bkelly · #3 11-23-2010, 02:56 AM

did you try taking apart & cleaning the wet side - my bearing seized and it was noisy before. the get crap in them and tearing them apart/soaking in vinegar really helps,

Madreefer · #4 11-23-2010, 03:12 AM

Ya I cleaned the wet side with vinegar. It's definetly the dry side. It's a rattling sound and I tried it with out the dry side attached for a second and the noise does'nt change. It appears as if the rotating part that has the screw I asked about is not in line 'cause when it powers down it looks like it is out of round. Thanks, I guess I wont be pulling any stickers off to adjust the screw since it will most likely void the warranty.

BlueTang<3 · #5 11-23-2010, 03:59 AM

http://www.reefcentral.com/forums/sh....php?t=1901337

DiverDude · #6 11-23-2010, 04:09 AM

There are just waaay too many problems with these Vortechs for the price they charge for them. Not to say that at half the price (where they should be priced) it would be any more acceptable for them to fail like this.

Makes me want a wavebox.

christyf5 · #7 11-23-2010, 04:15 AM

Quote:

Originally Posted by BlueTang<3

http://www.reefcentral.com/forums/sh....php?t=1901337

Oy! Do not do this if you still have a warranty (or even if you don't). Its a real beehatch getting those bearings off and you'll end up doing some real damage. Better off having ecotech deal with it (which is what I should have done instead of trying to get the bearings off and ultimately shattering the magnet).