|
|
|
|
|
#1
07-04-2010, 06:47 PM
|
|||||
|
|||||
Vortech help/thoughts
So I want to put my vortechs on the back of my tank. Here is the issue, I have a piece of black acrylic on the back of my tank with a small air gap between it and the glass due to the silicone holding it on. Without draining the tank and drilling holes in the acrylic for the wet side to sit in, do you think its ok to put them on the acrylic and compensate on the dry side for the thickness of glass, acrylic and air?
|
|
#2
07-04-2010, 07:57 PM
|
|||||
|
|||||
|
I can't see that being a problem. I wouldn't factor the air into the equation though, it doesn't affect the magnet in any way.
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free.
|
|
#3
07-04-2010, 08:27 PM
|
|||||
|
|||||
|
I'm guessing your worried about the acrylic cracking from the pressure of the magnets squeezing the acrylic up to the glass ? How thick is your acrylic and how much of a void do you think you have between the two ?
__________________
Mike 150g reef, 55g sump, T5's, Vertech 200A, Profilux III - German made is highly over rated, should just say Gerpan made. Reefkeeper - individual obsessed with placing disturbing amounts of electricity and seawater in close proximity for the purpose of maintaining live coral reef organisms.
|
|
#4
07-04-2010, 08:32 PM
|
|||||
|
|||||
|
it will work man , the new vortechs are made to run cooler and has the rubber piece to spread out the heat.
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think.
|
|
#5
07-04-2010, 09:26 PM
|
|||||
|
|||||
|
Quote:
|
Hybrid Mode
