what kind of screw should I use for a diy stand?

[nlreefguy]

Is there a particular type of screw I should use for the 2X4's? Are some screw more salt-resistant than others? I know stainless steel would probably be the best, but it seems rather expensive and is it perhaps overdoing things? Your opinions, please.

[Glennrf38]

I used galvenized deck screws. It's been 2 years now.

[hillegom]

I used painted deck screws from home depot

[Glennrf38]

Thats what I meant......... the brown ones......

[kien]

I used three different types and sizes of screws, some galvanized, some brown deck, and some plain stainless steel. In the end my entire stand including the screws and metal plates I used were all painted over with waterproof sealing primer and then a coat of waterproof paint on top of that Personally I would be more concerned about sealing the 2x4 wood to make sure they don't absorb water/moisture.

Also, it is a good idea to use wood glue on your DIY stand. The glue will make your stand a lot sturdier than just screws would. The glue also helps to seal cracks in between the wood :-)

[lastlight]

+1

I used the green deck screws just because I had a billion left-over from my fence build. It doesn't matter if you seal everything up. I like to fill screw holes with silicone and then seal the stand although this time I simply painted over all the screws with the same 3 coats of melamine the rest of the stand got.

Over a year DRY and no rust. Can you believe it?!

And yeah use wood glue. You have a much better chance of breaking the screws than the glue. You can't appreciate the glue's strength until you decide you don't like where you put a support and try to crowbar it out. You have a better idea when you decide the support can stay because you're tearing the surrounding wood the shreds.