|
|
|
|
|
#1
11-05-2007, 08:59 PM
|
|||||
|
|||||
Disinfecting Coral Cutters
I recently lost an RTN battle with one of my acros. During the process I used my coral cutters to frag it to try to save a piece (unsuccessfully). What is the best way to disinfect my cutters. I'm worried about transferring a bacterial infection to another coral the next time I frag.
Rob 
|
|
#3
11-05-2007, 10:30 PM
|
|||||
|
|||||
|
If you use bleach make sure you don't leave them to soak for more than a few minutes or you'll "rust" out the rivet that holds the two pieces together (in my experience anyways).
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free.
|
|
#4
11-05-2007, 11:31 PM
|
|||||
|
|||||
|
Quote:
 I use specialized rubber lined equipment to haul 19% bleach around. Regular household bleach is around 5-6% any higher and the average joe can make mustard gas with it. I assume you mean mixing it 5:1 ratio......and as far disinfecting I hold under water for 2 seconds to knock the big chunks of rust off ...never had a problem yet, but most of the time I use my hands.
__________________
Murray I reserve the right to hijack any thread I want to!! My carbon footprint is bigger than your carbon footprint !!!!
|
|
#6
11-06-2007, 01:11 AM
|
|||||
|
|||||
|
Doh
 I should have thought about it. Boiling them for 10 minutes should take care the nasties.Thanks Rob
|
Hybrid Mode
