|
|
|
|
|
#1
10-17-2007, 06:08 AM
|
|||||
|
|||||
Looking for a Diamond Hole Saw Bit to borrow for 3 holes...
I ended up buying the wrong size from ebay
 They were very cheap but I do not want to wait a few weeks to order more. I need a 2-1/2" size. I only need it for three holes. If you want, I can give you one of the ones I bought...maybe the 50mm. Never been used. Otherwise, I can compensate you for your troubles. If anyone can help out, that would be awesome. Or if anyone knows where I can buy one in vancouver for relatively cheap that would be great! 
|
|
#2
10-17-2007, 06:19 AM
|
|||||
|
|||||
|
Don't know about Vancouver but an alternative to ebay might be mops.ca - they have inexpensive drill bits too. Not too sure about lead time though.
I have that size, I'd mail it to you if you can't find anything local (you'd have to promise to mail it back  ) but .. well, its probably not any quicker than the other options.Surely someone in the L.M. can help you out though. Good luck!
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee!
|
|
#3
10-17-2007, 06:21 AM
|
||||
|
||||
|
Only have 1.5", 1" & 3/4". 2.5" is huge
 I've never needed larger than 1.5" on any of my tanks or the tanks I've drilled.
|
|
#4
10-17-2007, 06:31 AM
|
|||||
|
|||||
|
What tiny bulkheads are you using, Anthony? 1" Sched-40 already needs a 1-3/4" hole.
 I think 2.5" hole is what you need for a 1.5" bulkhead.
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee!
|
|
#5
10-17-2007, 06:32 AM
|
|||||
|
|||||
|
Yes, 1.5" bulkhead is what this is for.
|
|
#6
10-17-2007, 06:33 AM
|
|||||
|
|||||
|
Quote:
|
|
#7
10-17-2007, 07:26 AM
|
||||
|
||||
|
The sizes refer to bulkhead size, not actual drill bit diameter.
I find it less confusing to state bulkhead size since people know how big a bulkhead they want to install, but they don't usually know how big exactly will the hole be to fit a certain bulkhead size.
|
|
#8
10-17-2007, 07:27 AM
|
||||
|
||||
|
Have drilled at least a dozen tanks so far
__________________
If you see it, can take care of it, better get it or put it on hold. Otherwise, it'll be gone & you'll regret it!
|
Hybrid Mode
