![]() |
|
#1
|
|||||
|
|||||
![]() AM Readings before lights come on
ozone-mg/hr...90 ORP set point...377 ORP reading...356 Lights on reading drops gradually to below 300 Question: Is this normal New to Ozone |
#2
|
|||||
|
|||||
![]() Anyone with Ozone knowledge are the readings normal in the above thread
|
#3
|
|||||
|
|||||
![]() well ron, i dont personally have experience using ozone but i'm pretty sure if you are using it, it should read between 300 - 400. hope that helps
|
#4
|
|||||
|
|||||
![]() I aim for an ORP of at least 400. Dosing about 25-30mg/ml (I know its low) in a 90 gallon tank. Apparently you can go as high as 450 or so.
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free. |
#5
|
|||||
|
|||||
![]() Thanks for your input Christy and Colin
Did a little reading: ORP reading one should stay between 300 and 350mV This is recommened as the desirable level Values higher then 430mV can be dangerous Values below 200mV indicate an accumulation of organic wastes and low oxygen level |
#6
|
|||||
|
|||||
![]() Really? What was your source? Things I've read say to keep it at 400+. Hmm, maybe I should read more. Right now I've been aiming for about 400 but hovering around 370 or so. Perhaps I should just keep it where it is
![]()
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free. |