|
|
|
|
|
#1
02-13-2007, 07:11 PM
|
|||||
|
|||||
Joe Reefer's Inwall 120 V2.0 (Updated)
Well folks, Its time to start a thread on the tank I have been working on the last six months or so.
The system will consist of: -120 gallon display (48x24x24) -30 gallon sump -20 gallon prop -20 gallon fuge Equipment: -Panworld 200ps (main circulator) -AB Aquatics 56" dual recirc. beckett -Tunze wavebox -Tunze Stream 6100 w/controller -Tunze Stream 6060 -AB Aquatics kalk reactor -DIY calcium reactor Display Lighting: -2x250w megachrome c/w lumenarc mini reflectors, pfo e-ballasts -2x48" T5 actinic c/w reflectors and IceCap 430 ballast Prop Lighting: 1 250w HQI 10k XM c/w icecap ballast and pfo reflector
__________________
M2CW Last edited by Joe Reefer; 02-19-2010 at 07:03 PM. 
|
|
#2
02-13-2007, 07:13 PM
|
|||||
|
|||||
  
__________________
M2CW
|
|
#3
02-13-2007, 07:21 PM
|
|||||
|
|||||
   
__________________
M2CW Last edited by Joe Reefer; 02-13-2007 at 08:19 PM.
|
|
#4
02-13-2007, 07:22 PM
|
|||||
|
|||||
 
__________________
M2CW
|
|
#5
02-13-2007, 07:52 PM
|
|||||
|
|||||
|
Holy mackerel, nice setup.
Question, why did you go with 2 bends on the intake side of your sump return? It looks like the pump could have fit sitting perpendicular (although sticking out a little) and then you'd only have to worry about one 90 degree bend. (To be honest I'm not sure about this whole restricting the input of pump, about how far you need to go with that. I had 2 90's on my pump a few years ago but I stepped up the pipe size to be on the safe side, things were fine. But I've seen people not feel right about even using a bushing on a pipe to fit a 1.5" pump input to a 1" bulkead. So I'm not sure where I sit on this one.) I was gonna comment about how clean the plumbing looks, but then I realized after looking at the skimmer closeup that they must be dryfitted in the first few pictures there.  Nevertheless that is an amazing maze of pipework, good work!!  How does the fuge drain into the sump, I don't see the drain line for that one? Come to think of it .. I don't see the feed line going into the tank, is it capped off for now? I see it start and can follow it along to a point, then suddenly I don't see it anymore.
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee! Last edited by Delphinus; 02-13-2007 at 08:06 PM.
|
Hybrid Mode
