![]() |
|
#1
|
|||||
|
|||||
![]() i feel like a bit of a knob asking this question but here goes nuthin. does anyone have one of these reactors? i've got a CR-1 that has, what i believe to be terrible instructions so i, for the life of me cannot figure out how to hook it up.
![]() thanks,
__________________
Darryl Last edited by fishface; 01-31-2007 at 07:52 PM. |
#2
|
||||
|
||||
![]() Why a knob? It's a good question. I built a couple Ca reactors as have a lot of people here but I'm sure someone in Surrey can help you out with it.
Doug |
#3
|
|||||
|
|||||
![]() Hey Darryl, If you need a hand I could swing buy some time. Or if you take a pic or link to the instructions online I'm sure we could all help figure it out
J |
#4
|
|||||
|
|||||
![]() Quote:
there's a JG fitting at the bottom, top and a 1/2 inch fitting on top as well. if you look really carefully, there's also a bubble counter on the right hand side behind the riser tube. my best guess is thst's where i connect the CO2 but the other ones i'm not sure of. ps. not sure what the extra valve on the table is for either ![]()
__________________
Darryl Last edited by fishface; 02-04-2007 at 06:50 PM. |
#5
|
|||||
|
|||||
![]() Ok so there has to be a water in. a water out and a CO2 in. Typically the water out is controled by a valve or some sort and the CO2 in is through a bubble counter. In many reactors the water in is at the botom and the water out is at the top. Does this make any sense.
J |
#6
|
|||||
|
|||||
![]() i have a reactor just like this by marinetech. the water in is at the bottom near the pump. the water out is at the top of the chamber. you plumb the shutoff valve at the top of the chamber water out line to control your effluent. the co2 in is at the top of the bubble counter chamber. hope this helps. any other questions feel free to ask. hope i was clear, i'm at work so rushed to write this
|