|
|
|
|
|
#1
06-27-2006, 01:11 AM
|
||||
|
||||
tds meter question
i just installed my new inline tds meter and was wondering is it possable for my ro/di unit to be taking out 100% of the particles in the water??? i would suspect not... it gives me a reading of 124ppm coming into the unit and a readin of 000 coming out of the unit.
is that possable that my ro unit could be that efficient? Richard 
|
|
#2
06-27-2006, 01:49 AM
|
|||||
|
|||||
|
After I change the filters on my 5stage Aqua Clear my hand held tds reads 0. It is starting to creep up to 2 then 3 after about a month and a bit. I don't know how accurate mine is but it was recomended for mthis site it's a milwalkee.
|
|
#3
06-27-2006, 02:19 AM
|
|||||
|
|||||
|
mine reads 0 after coming out of the unit. if it doesn't then whats the point?
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free.
|
|
#4
06-27-2006, 03:20 AM
|
||||
|
||||
|
well i agree that a reverse osmosis unit should be efficient but i thought they where like 83% efficient or sumthing like that.
Richard
|
|
#5
06-27-2006, 01:48 PM
|
|||||
|
|||||
My TDS inline reads 0(new filters), then will creep up as time goes on, Calgary water is not that hard to clean up.......
__________________
Richard _______________________________________ My wife believed me when I told her it was only going to cost about $500.00. that was over two years ago and I'm still grounded..... 
|
|
#6
06-27-2006, 02:35 PM
|
|||||
|
|||||
|
Mine reads zero. Mine is a RODI, so after the RO membrane is the deionizer, which basically traps any particles left in the water. Once my DI runs out, my levels are above zero.
|
Hybrid Mode
