|
|
|
|
|
#1
12-27-2005, 07:49 PM
|
|||||
|
|||||
Seio 820 and Magfloats
Has anyone glued one to a big Magfloat yet? My suction cups have finally gave way and I had a mess in the tank this morning. My biggest concern for using a mag float is if the magnet will mess up the motor, afterall magfloats are damn strong magnets. - Thanks
__________________
"what do you mean you need another tank??" Last edited by Gizmo; 12-28-2005 at 05:00 AM. 
|
|
#2
12-27-2005, 09:04 PM
|
|||||
|
|||||
|
ya i have done it with the 820 and works very well. I used PVC cement to bond it.
What i did was scratch up the magnet and took the piece and glued it and then put glue around where the lip of the plastic is. amazing too. i see if i can find a picture ok.. mike
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think.
|
|
#3
12-27-2005, 09:19 PM
|
||||
|
||||
|
I know one of my hagan pawerheads, which I know is much weaker than a seio, freaks out whenever I get close to it with my mag float......I'm sure the seio will be different but I'd run it next to the magnet first to make sure it's okay....
Just my opinion... Aaron
|
Hybrid Mode
