|
|
|
|
|
#1
12-10-2005, 03:06 AM
|
||||
|
||||
frustrated with leaking
I have had this 92 gallon glass oceanic reef ready corner tank for months now and I can't even use it ! I'm at my wits end wit this thing !
I've been trying to seal it over and over but it still leaks from the underneath the overflow pipes. =( I've tried sealing it on the inside of the overflow, I've tried sealing it from underneath where the water drips out...but it still leaks ! I've used 2 tubes of silicone on this thing. I'm so frustrated! If you've got any advice please dish it up because I'm at a loss here. =( Thank you asherah 
|
|
#2
12-10-2005, 03:32 AM
|
|||||
|
|||||
|
erm.. not sure how your plumbing is, but if the nut on the bulkhead is on the outside of the tank where you can get to it easier, I find using a flathead screwdriver and a hammer to tighten it until the bulkhead is very tight against the glass, creating a much tighter seal. I tried this after noticing some salt creep on my bulkhead, hasn't come back since.
..not too sure if that helps. 
__________________
a tout le monde, a tous les amis. je vous aime, je dois partir.
|
|
#4
12-10-2005, 05:31 AM
|
||||
|
||||
|
have you tried replacing all the plumbing? There might be a small crack somewhere that you can't see. I would clean off all silicone and inspect everything with a magnifying glass and you might see something.
__________________
Hi, my name is Jason and I\'m addicted to reefs
|
|
#5
12-10-2005, 06:48 AM
|
||||
|
||||
woohoo it's fixed !!!
We ripped out all the silicone, took all the peices out checked them all over. My husband checked it all out and turns out I had the rubber gaskets in upside down. DUHHHHHH!!!! Sheesh ! All that effort siliconing for nothing =p Ah well at least it's fixed =) Thanks everyone asherah
|
Hybrid Mode
