Deltec MEC 300 - What a Racket!

[Oscar]

I just plugged in my brand new unit. The pin wheel on the Maxi jet 1000 makes quite a racket even before I open the air valve. Then when I open the air valve it sounds like a plane is taking off.

I have an older Maxi jet 1200 that I am going to swap out to see if it is quieter.

In the mean time any suggestions to reduce the noise?

[BlueTang<3]

It's properly primed ? My 600 is loud if it has air in it

[Oscar]

That could be it. What is your trick for priming? Trying to get the last 3 inches of air out of the intake pipe is proving to be a challenge.

[subman]

http://www.theaquariumsolution.com/mce600-lazy-start

based on the 600 but could have some hints to.

[lee9]

I used a Deltec MCE300 for awhile. I didn't seem to have any issues getting all the air out of the line. I just plugged the air intake hose completely with my finger and after 30 - 60 seconds it would pull all the air out of the system.

Maybe the pump is going and there is not enough pressure to pull the water through? You had the same results with your other pump. Good luck.

Originally Posted by Oscar

That could be it. What is your trick for priming? Trying to get the last 3 inches of air out of the intake pipe is proving to be a challenge.

[Oscar]

Originally Posted by lee9

I used a Deltec MCE300 for awhile. I didn't seem to have any issues getting all the air out of the line. I just plugged the air intake hose completely with my finger and after 30 - 60 seconds it would pull all the air out of the system.

Maybe the pump is going and there is not enough pressure to pull the water through? You had the same results with your other pump. Good luck.

Thanks Lee9. Now I have discovered that the pin wheel impeller has broken. For the time being I will install a regular Maxi Jet impeller. Then I can see if I can get the unit properly primed and running while I try to get a replacement impeller.

[Oscar]

Update:

I reinstalled the pump even with the broken impeller and it surprisingly works and is generating bubbles and full flow.

There were 2 steps to get the pump primed:

1. As Lee9 suggested put my finger on the end of the intake valve for 10-15 seconds to allow the pump to build up a bit of pressure.

2. Do not open the air valve to 100%. Turn it until you hit the "SWEET SPOT" where the pump becomes almost silent. That trick was posted on the DD website although it does not appear in the manual.

Thanks all for the prompt feedback.

[BlueTang<3]

Good To Hear