Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Reef

Reply
 
Thread Tools Display Modes
  #1  
Old 11-03-2011, 06:07 PM
ScubaSteve ScubaSteve is offline
Member
 
Join Date: Nov 2009
Location: Vancouver
Posts: 1,591
ScubaSteve is on a distinguished road
Default Weigh in with your experiences with biopellets or vodka dosing

With my new system up and running now (albeit in sore state after the crash that followed the transfer ) I am wanting to start implementing all of the features that I have always wished were on my tank. One thing I have always wanted to do was carbon dosing of some sort, be it biopellets or vodka dosing.

I typically keep the system heavily stocked with corals (I will be shooting for this again once the tank turns around) and I like to feed on the heavier side as this helps me get some awesome growth out of the corals. However, this has had me doing big weekly water changes for the past two years and I'm tired of it. I'd like to have a system where I can feed a bit on the heavy side without having to worry about water quality as much. I'd love to use a macro refugium and go au natural but this isn't in the cards for me because of space limitations. So, enter carbon dosing...

I'd really like to give this a try. I've done my homework, I know what I'm doing and I've narrowed it down to dosing MB7 and vodka or swapping my Phosban reactor over to biopellets. I've been reading good and bad things for both (I think the bad comes mostly from people underfeeding) and can't quite decide which route is the best way to go. I've eliminated zeovit for a few reasons but the biggest being cost (I be a poor grad student).

I was wondering if anyone can weigh in with their experience with either method? I'd love to hear your stories!
Reply With Quote
  #2  
Old 11-03-2011, 06:38 PM
spawn spawn is offline
Banned
 
Join Date: May 2010
Location: calgary
Posts: 515
spawn is on a distinguished road
Default

IME vodka has worked effectively for me. I followed the directions on this site
http://reefkeeping.com/issues/2008-08/nftt/index.php
Reply With Quote
  #3  
Old 11-03-2011, 08:01 PM
TimT's Avatar
TimT TimT is offline
Member
 
Join Date: Nov 2001
Location: Courtenay, BC
Posts: 600
TimT is on a distinguished road
Default

Since you said your a "poor grad student" just use the Vodka Sugar Vinegar method minus the vodka. So use 750ml RO water, 3tbsp white sugar and 175ml plain white vinegar. Go slow and gradually increase the dosage. I use this method myself for nitrates and then I use the Foz Down to eliminate the Phosphates.

I will be switching from Rogers white sugar as it is made from GMO Round Up Ready Sugar Beets.

Cheers,
Tim
Reply With Quote
  #4  
Old 11-04-2011, 07:26 AM
ScubaSteve ScubaSteve is offline
Member
 
Join Date: Nov 2009
Location: Vancouver
Posts: 1,591
ScubaSteve is on a distinguished road
Default

Thanks guys, VSV is sort of the way I have been leaning as I believe in the idea of multiple carbon sources to avoid creating a bacterial monoculture, but I really like the idea of having the biopellets basically run themselves. When the PhD gets busy, maintenance can slide a little somI want to make some things a bit more automated.

Tim, if I used VSV, how much vodka would you add to that recipe you have there? Would I follow the same dozing scheme as vodka or do I have to wing it, go slow and just feel it out (by which I mean test kit)?
Reply With Quote
  #5  
Old 11-04-2011, 02:22 PM
Reef Pilot's Avatar
Reef Pilot Reef Pilot is offline
Member
 
Join Date: Nov 2010
Location: Langley BC
Posts: 1,883
Reef Pilot is on a distinguished road
Default

Well, am still pretty early to have good meaningful results, but am trying the Vertex UF-20 reactor with the Vertex Pro-Bio Pellets. Started a couple months ago, but ramped up very slowly with small additions. Just yesterday, I am now finally up to the maximum recommended bio pellets in my reactor.

For me, it is as much an experiment as anything. I had very high nitrates in my long running, very mature, tank, and wanted to see if I can bring them down, without taking out all my sand and live rock to clean them, and resetting the entire tank. I have a heavy bio load, as I feed my fish about 4 times a day, although small portions.

The nitrates were as high as 100, yes, very high, and are now down to about 40. Amazingly, my corals (no fancy or delicate ones) all seem to be doing well, and fish are active and healthy.

Probably because I ramped up slowly, I did not have any cyano issues or initial tank cloudiness that some others have reported. I did change my skimmer pump, which may have been my big problem all along. It was only pulling about a cup of skimmate a week before, at best. Now I get that everyday, and more, if I don't dial down the water level in my skimmer. I also use MB7 to ensure a good bacterial culture.

So now that I am fully ramped up, will be interesting to see if this will bring my nitrates down all the way or not. I am continuing my feeding as before. My P04, tested (Hanna) last a few days ago, was at .47.
__________________
Reef Pilot's Undersea Oasis: http://www.canreef.com/vbulletin/sho...d.php?t=102101
Frags FS: http://www.canreef.com/vbulletin/sho...d.php?t=115022
Solutions are easy. The real difficulty lies in discovering the problem.
Reply With Quote
  #6  
Old 11-05-2011, 05:58 AM
chris121277's Avatar
chris121277 chris121277 is offline
Member
 
Join Date: Nov 2008
Location: Fruitvale B.C.
Posts: 521
chris121277 is on a distinguished road
Default

just tagging along here
__________________
90 Gal mixed reef with a custom 40 gal sump, SWC Mini S skimmer, 8X56 Watt fan modded Tek, 2x2LF reactors, mag 12 return, Tunze ATO and a modded Tunze 6100 running on a DIY wave controller
My TOTM thread http://www.reefersparadise.com/smf/i...?page=page4263
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 12:37 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.