building a sump...need some help

[rjengen]

So a long story short, I've cracked my second sump and am finished with drilling holes in them, as well as running external pumps as a return. I am no good with the CAD programs some of you guys use so I can't really draw you a picture of what I'm going to explain, so use your imagination

I'm building a new sump right now that's 36" x 18" x 18" and in the end is going to be eurobraced. All the glass is here, and it's slowly going together. Before I put the bracing on though, I was wondering if you guys could help me out with planning the guts. I'd like to build a fuge into it, and still have room for my skimmer, bubble trap, and return section for a pump. Can it be done, and does anyone have good any good pictures of their sump so I can go by something. If you can help me out...I'd be your slave!

[sphelps]

I just built a sump with very close dimensions which contained a mechanical filtration chamber, carbon tray, skimmer chamber, refugium and a return run to an external pump. I have cad drawings but they are at work, could possibly post them tomorrow with some pics of the finished product as well if you can wait.

[The Grizz]

Check out my build on my 165. Just finish a acrylic sump with 6 compartment. Intake, Refugium, skimmer 1, skimmer 2, dual PhosBan reactor & return. 46" x 22" x 16"

[rjengen]

sphelps...I'm not planning to order the glass for the baffels until late next week, so no rush at all.


Grizz...Your sump is killer man, if I had an extra 4 feet of main tank I would be a third wheel taking your design. Building a new house this fall, so who know's...I might just get that big tank I want

[The Grizz]

You could adapt my design to fit your sump dimensions. Put your refugium first, skimmer section just big enough for the skimmer and make your return small as it really does not have to hold much water.

Split you sump 12" back - 6" front, but refugium 1st, then skimmer, bubble trap and then return.

[whatcaneyedo]

I'm more of a big ugly stock trough person myself but Melev has a lot of sump designs and advice on his site here http://www.melevsreef.com/allmysumps.html just look down the left hand column for the different models.

[sphelps]

OK here's the general layout done in CAD followed by the final product pictures. In the CAD drawing all features are not shown and I altered the final product slightly to accommodate for a higher flow rate. The basic dimensions are the same though. If you omit the water reservoir you'll end up with dimensions very close to what you're looking for (30x18x16). Also please note that this is purely for reference purposes only, not open to criticism and was designed for someone else. Your exact needs/wants will not necessarily match this exact model.