NEED HELP WITH MP10

[Cujo#31]

Ok. So I got the infamous red/green flash on my driver the other day indicating a pump stall. Checked wet side, turning freely, checked dry side, turning freely. Tried power....red/green flash.
Then started the process of eliminaton. Swapped dry sides to drivers. Same error, same side. Switched everything back to original, swapped wet sides. Same error, same side. Figured I had it ruled out to faulty dry side. Took it apart to see if there was a cause.....nothing. so.....off to J&L today, $140.00 later I have my new dry side. Get it home. Hook everything up.....red/green flash. WTF?????? No matter which circuit board I hook to faulty side I get red/green but no fault code on other side. Even tried switching power supplies...nothing. CAN ANYONE HELP!!!!!!

[rusty shackleford]

Did you try clearing the memory on it ?

[Cujo#31]

Originally Posted by rusty shackleford

Did you try clearing the memory on it ?

If you mean the "heard reset" yes. It won't even allow me to do that when hooked up to faulty side. If you are talking by way of using a computer....way beyond me bud

[Cujo#31]

Originally Posted by rusty shackleford

Did you try clearing the memory on it ?

And when I swap circuit boards the driver works perfectly on other side. If I hook working driver to faulty side I get same fault code.

[rusty shackleford]

Try holding the mode button , does it respond at all ?

[Cujo#31]

Originally Posted by rusty shackleford

Try holding the mode button , does it respond at all ?

Ya.....it responds by flashing red/green. I just did hard reset again by switching board to other side and still nothing

[rusty shackleford]

So you're saying that from the time you plug it in , right off the bat it's red/green and will not respond to anything ?

[Chase31]

Try a new power supply, mine flashed red and something but not sure what one. I would assume it's the power supply (24v converter)


Sent from my iPhone using Tapatalk

[Cujo#31]

Originally Posted by Chase31

Try a new power supply, mine flashed red and something but not sure what one. I would assume it's the power supply (24v converter)


Sent from my iPhone using Tapatalk

I tried each different power supply each and every time with no luck