![]() |
|
View Poll Results: Sand bed or no sand bed for a sps tank with clams | |||
YES |
![]() ![]() ![]() ![]() |
44 | 40.37% |
NO |
![]() ![]() ![]() ![]() |
13 | 11.93% |
Small layer 1-2 inches |
![]() ![]() ![]() ![]() |
56 | 51.38% |
3-4 inches |
![]() ![]() ![]() ![]() |
13 | 11.93% |
Multiple Choice Poll. Voters: 109. You may not vote on this poll |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||||
|
|||||
![]() ![]()
__________________
Though a tree grow ever so high, the falling leaves return to the root. 300DD - 140DD ![]() TOTM Fall 2013 |
#2
|
|||||
|
|||||
![]() Personally, I don't like the look of a bare bottom tank. One thing to consider though is that you'll likely have lots of flow in an SPS tank, so don't pick a fine grain sand. Something a little bigger is better, otherwise your sand will blow around a lot... you likely already know that though!
__________________
-Murdoch 160 gallon Reef, almost all SPS, a few LPS, small handfull of Zoas, and 5 clams. LOVING the upgrade (now that most of the work is done!) My tank Journal: http://www.canreef.com/vbulletin/showthread.php?t=75924 |
#3
|
|||||
|
|||||
![]() That's the predicament I am faced with. I got 4x6105 and a wavebox. Some times when the pump gets bumped by a fish and it will start a sand storm. I think I am gonna go with a bare-bottom for starters and if I don;'t like the look of it I'll just add a bit of sand.
__________________
Though a tree grow ever so high, the falling leaves return to the root. 300DD - 140DD ![]() TOTM Fall 2013 |
#4
|
|||||
|
|||||
![]() I have 2 6105s in a 160... with 2 waveboxes... theres a little sand blowing, but for the most part, you just need to aim the 6105s... should be good from there.
__________________
-Murdoch 160 gallon Reef, almost all SPS, a few LPS, small handfull of Zoas, and 5 clams. LOVING the upgrade (now that most of the work is done!) My tank Journal: http://www.canreef.com/vbulletin/showthread.php?t=75924 |
#5
|
|||||
|
|||||
![]() Probably a lot easier than the other way around.
__________________
Brad |
#6
|
|||||
|
|||||
![]() HAHA 10-4 on that ![]()
__________________
Though a tree grow ever so high, the falling leaves return to the root. 300DD - 140DD ![]() TOTM Fall 2013 |
#7
|
|||||
|
|||||
![]() I also don't personally like the look of a bare bottom. 1-2 inches is nice.
__________________
![]() Setup: 180G DT, 105G Refuge (approx. 300lbs LR, 150lbs Aragonite) Hardware: Super Reef Octopus SSS-3000, Tunze ATO, Mag 18 return, 2x MP40W, 2X Koralia 4's Wavemaker Lighting: 5ft Hamilton Belize Sun (2x250W MH, 2X80W T5HO) Type of Aquarium: mixed reef (SPS & LPS) with fish Dosing: Mg, Ca, Alk |
#8
|
|||||
|
|||||
![]() Does any one think that fine sand particles can cause a sand blasting effect on the sps coral, or am I just crazy? I get way better PE when I turn down the flow on my pumps and the water has less particulates. just curious if anyone has experience that before?
__________________
Though a tree grow ever so high, the falling leaves return to the root. 300DD - 140DD ![]() TOTM Fall 2013 |
#9
|
|||||
|
|||||
![]() I use fine sand, and have 2 MP40W powerheads, also until recentlay had 2 #4 Koralias wavemakers going as well. Never had any issue with sand. But again my tank height is 27inches.
__________________
![]() Setup: 180G DT, 105G Refuge (approx. 300lbs LR, 150lbs Aragonite) Hardware: Super Reef Octopus SSS-3000, Tunze ATO, Mag 18 return, 2x MP40W, 2X Koralia 4's Wavemaker Lighting: 5ft Hamilton Belize Sun (2x250W MH, 2X80W T5HO) Type of Aquarium: mixed reef (SPS & LPS) with fish Dosing: Mg, Ca, Alk |
#10
|
|||||
|
|||||
![]() Yes I've experienced this myself. One reason I put my filter socks back on.
|