|
|
|
#1
12-01-2007, 03:51 PM
|
|||||
|
|||||
bulkhead fittings for curved surfaces
Ok, I remember a year or two ago people were using some sort of push in gromet for sealing pipes going through the sides of skimmers, reactors, ect..
where can you get them and how do they work? Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive. 
|
|
#3
12-01-2007, 04:25 PM
|
|||||
|
|||||
|
buy them
cheap here:
http://www.wernersponds.com/uniseals%20sizes.htm more expensive here: http://www.aquaticeco.com/index.cfm/.../8600/cid/2009
__________________
____________ If people don't die, it wouldn't make living important. And why do we fall? So we can learn to pick ourselves up.
|
|
#4
12-01-2007, 04:49 PM
|
|||||
|
|||||
|
Ok so can they be used on different diamiter walls or do they have a range?
Steve
__________________
*everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive.
|
|
#5
12-01-2007, 09:45 PM
|
|||||
|
|||||
|
YOu can use them up to 1/2" or 3/8" wall IIRC. 1/8" wall is the thinnest I would use. 1/4" wall works much better than 1/8".
__________________
32"x32"x20" Cube-ish tank
|
Linear Mode
