Bypass the controller on a DC pump?

[FishyFishy!]

Well, one of my DC10000 pumps is failing. Luckily it's the one feeding the frag tank/fuge and not the display.

I think it's the controller, but i'm unsure. It may be the pump as well. Every time I disconnect power to it and then re-start it, it works for about 2 minutes, then stops. Controller shows full power bars.

So is there a way that I can bypass the controller and just have it full speed all the time? I don't use feed mode or the flow control on this pump. It stays on all full power all the time.

Thoughts?