![]() |
#1
|
||||
|
||||
![]() As many other may encounter a yellowing splash guard, I figured that I will post how I constructed a DIY splash guard for my 29g Oceanic Biocube, which is no longer supported by Oceanic (since they now make them under Coralife brand name and the splash guard is a little different).
After 4 years, my acrylic splash guard started yellowing and I had to come up with something, as even brand new lights would not support some of my corals. I contacted Oceanic, but they did not have a replacement. Following an advice on a different forum, I asked a local plastic shop (Industrial Plastic in PoCo) to cut the following sizes of acrylic (3mm thickness): 1 18.5in x 10.5in 2 18.5in x 1.5in 2 10.5in x 1.5in Was ready within a day. Total $35 including labour quite pricey but the corals are happy. I aligned and glued the pieces together with cement glue (for acrylics). I added scotch tape at the corners for the time being. I only used a tiny amount of cement glue since it is toxic for the fish. An hour later I used Aquarium silicone to silicone all the cracks both inside and outside of the splash guard (make sure all cement glue is coated with silicone). Waited for another 24h to dry as per instructions, and until it stops smelling. I drilled the holes with a Miliwaki wood drill bit (make sure acrylics is against flat surface (piece of wood) and tape the area that will be drilled. For the screws, I used 2 size 6. Worked really well. Total cost was $55. The fit is not as snug as the original splash guard, but is pretty good. To prevent condensation inside the splash guard, the rear door has to remain a little open. Good luck and let me know if you would like to see some photos... Eddie
__________________
My 29g Biocube: http://www.canreef.com/vbulletin/showthread.php?t=62808 |
#2
|
||||
|
||||
![]() Eddie,
Please share your photos of your splash guard. Sent from my iPad using Tapatalk |