leaking from bulkhead?!?!

[manaf]

so i think im leaking from my output coming from the sump (drilled from bottom)
now just wanting to know what are my choices ? its a fully setup reef too

not leaking alot but enough to make a little puddle , im guessing there isnt no glue that is reef safe and can bond in water ahah

[manaf]

oh and its a 72 gallon bowfront

[Dyspnea]

Try tightening the bulk head a little bit, but make very small adjustments. If no improvement you may need to replace it

[Adrenaline101]

Sorry if I'm getting this wrong, is it leaking from a bulkhead on the sump or the bulkhead on the bottom of the tank. Is the bulkhead inside of an overflow box?

[manaf]

its leaking from the bottom of the tank onto the sump the output is not in a over flow, runs through a one way valve so water can only go out ,

so tightening it might be hard to reach from where the sump is would have to try doing in through the tank??

[Myka]

Originally Posted by manaf

its leaking from the bottom of the tank onto the sump the output is not in a over flow, runs through a one way valve so water can only go out ,

so tightening it might be hard to reach from where the sump is would have to try doing in through the tank??

Could you take a pic? This sounds odd. I can't imagine a bulkhead positioned so it could be tightened fro inside the tank. It should require tightening from the outside of the tank, but your setup sounds uncommon.

[manaf]

the hose on the right is the out take and is the one leaking sorry if the pictures are choppy