![]() |
#1
|
|||||
|
|||||
![]() My corals did fade a bit after upgrading to a 400 watt 10K bulb from a 250 watt 14K bulb. I slowly increased the photo period over 3 weeks until a full 12 hours was achieved. Its been over a month now and some of my corals are still looking a bit washed in color, is this normal? All levels are good, but my calcium is consistantly on the lower side; around 330ppm regardless of how much I buffer with kalk etc. (I suspect my test kit is bad)
__________________
THE BARQUARIUM: 55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's. Fully stocked with fish, corals and usually some fine scotch http://www.canreef.com/vbulletin/showthread.php?t=55041 |
#2
|
|||||
|
|||||
![]() Quote:
Steve
__________________
![]() Some strive to be perfect.... I just strive. |
#3
|
|||||
|
|||||
![]() I found my calcium consumption skyrocketed after upgrading my lights, so you may have to adjust your dosing. First though, get a kit and be SURE of your levels... How is your alk? High alk, (13+ dKH), will precipitate Calcium causing low levels, as will Magnesium deficiency as Steve said... Read Beverly's links.... it's a wealth of info. Since I read and came to understand those I have had no problems identifying and correcting chemistry issues in my system, but I do know that increased photosynthesis is definitely going to affect calcification and therefore consumption levels as I have experienced that first hand.
As for fading I believe 14K bulbs will show colours better, while 10K will give better growth as a result of increased available lumens.
__________________
135G Mixed Reef. Bullet 2, 25 gal refugium, 2 X250W MH + 4X 96W PC\'s, DIY Calcium Reactor, Coralife 1/6 HP Chiller, Phosban, Tunze, 2 closed loops & SQWD\'s, Seios, Coralife 4 stage RO/DI & a bunch of other expensive gadgets... I may never retire, but I'm gonnahavahelluvanaquarium! |
#4
|
|||||
|
|||||
![]() My last MG test was about 1220ppm, but its a Ca/MG test kit so it could be off too. Alk has been pretty constant at 2.5-3.5 Meq/L since changing to reef crystals a month ago.
Did your Ca consumption level off after a while when you upgraded your lights, or did it stay higher?
__________________
THE BARQUARIUM: 55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's. Fully stocked with fish, corals and usually some fine scotch http://www.canreef.com/vbulletin/showthread.php?t=55041 |
#5
|
|||||
|
|||||
![]() Quote:
Steve
__________________
![]() Some strive to be perfect.... I just strive. |
#6
|
|||||
|
|||||
![]() Ya, I've been slacking in the MG department lately. Due to my anemone mishap last night (other thread) I'll be doing a LARGE water change tonight, so that should help out a bit.
__________________
THE BARQUARIUM: 55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's. Fully stocked with fish, corals and usually some fine scotch http://www.canreef.com/vbulletin/showthread.php?t=55041 |
![]() |
Thread Tools | |
Display Modes | |
|
|