DIY Steel Stand Construction Structural questions

[jgoldsney]

Well I am slowly getting around to setting up my new tank, I purchased it used from a friend and it came with quite a nice oak stand and canopy.

The problem is that the Oak doesn't really go with the house and I find that the stand is a little tall which will make working in a 30" deep tank a real pain.

I decided that I would like to weld my own stand out of steel, I was thinking of 1" or 1 1/4" Heavy Wall square Tube.

Now for the question

I would like to if possible have no vertical supports on the front access to the stand. I will be attaching wood panels with magnets and I would like to have unrestricted access if possible one I remove the panel. (Thanks Dez for the idea of the magnets)

What I am wondering is if I made a beam of sorts for the tube that runs accross the top on the front that would be made out of 2 lengths of square tube with some vertical supports (hpefully the ASCII dwg below clarifys)

--------------------
Top Tube
--------------------
||| |||
||| ||| <-support tubes (about 6" space between)
----------------------
Bottom Tube
---------------------

What I am wondering is if this is feasable or if I am just asking for trouble


Joel

---------------------------------------------------
Top Tube
-----------------------------------------------
|*|<-Corner Post |*|<-Sup Tube|*|<-Sup Tube
|*|----------------------------------------------------
|*|Bottom Tube of beam
|*|--------------------------------------------------
|*|
|*|
|*|--- Clear access to inside of stand here---
|*|
|*|
|*|----------------------------------------------------
|*|Bottom Tube of stand
|*|--------------------------------------------------