![]() |
|
#1
|
||||
|
||||
![]() As the title states, I have some beautiful, very bright and healthy GSP. Problem is it is growing to well as normal and starting to crowd and choke other tank inhabitants out. Namely a Chalice which I am quite fond of. There is also another SPS that I am getting worried about if I can't scale it back. I've tried to peel, pick, tear, pull, pry and harass the GSP off however short of pulling the rocks out which have been drilled and pinned in a big formation and taking a blow torch to it I am not sure what else I can do.. Looking for ideas please... Im a pretty new person to the saltwater arena, this tank has been up for just over 2 years now and has finally started to go good. It is on a very coarse rock, Not Fiji, or Tonga or Marco rock. Not really sure what type it is... Anyhow, I am very open to suggestions please and thank you...
|
#2
|
|||||
|
|||||
![]() When I had the stuff growing out of control, I was generally able to pry it off using a screwdriver or other similar implement and once it started it would more or less come off in manageable sized chunks.
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee! |
#3
|
|||||
|
|||||
![]() You could epoxy or glue over it. Or find another coral that's easier to manage that will sting the GSP. My RBTA had no issue killing gsp
![]() |
#4
|
|||||
|
|||||
![]() One of these ought to do the trick:
https://www.youtube.com/watch?v=GWP9thPs_mM https://www.youtube.com/watch?v=vqyBr8KZwqo |
#5
|
|||||
|
|||||
![]() Kalk paste might work, (google techniques, dangers, etc). Or else you may just have to grind at it a little every day until it finally gives up. Mucking gloves from Lee Valley will make it a little less tiresome reaching into the tank.
Last edited by soapy; 01-26-2016 at 12:07 AM. |
#6
|
|||||
|
|||||
![]() Don't think there's really a quick/easy solution that won't potentially harm other stuff. Manual removal as you've been doing is probably the best way. It's what I do. Tweezers, picks, narrow/sharp implements make the job a bit less tedious. Get a little lip started by prying with a sharp/flat implement & then the tweezers or forceps.
It's a bit like weeding a garden, very therapeutic for some folks, not so much for others. Character builder for salt water hobbyist & often a factor causing some to throw in the towel! Hair algae anyone?
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build ![]() |