![]() |
#1
|
||||
|
||||
![]() Using the gel like everyone recommends and it does not seem to cut it.tried lots,little ,tried massaging it into the rock,tried letting it set a bit but nothing works great? What am I missing ?
__________________
150 gallon reef mostly softies/lps. 50 gal sump with bubble magnus skimmer/ Led fuge light/refugium/ 1200 return and tunze powerheads. Dual pharoah main tank led.4 pump dosser. 550 gallon stingray tank water drip system 150 bowfront. 75 turtle tank, many others |
#2
|
|||||
|
|||||
![]() What are you trying to glue to what?
|
#3
|
||||
|
||||
![]() What type of glue? Using a marine glue?
The ecotech glue is reliable and will set under water. Sent from my iPhone using Tapatalk |
#4
|
|||||
|
|||||
![]() I usually make a small ball of epoxy, and put the gel glue on one side, glue it to the frag, and put glue on the other side and squish it into place.
|
#5
|
||||
|
||||
![]() I'm just using crazy glue advanced gel but I will order some of the stuff you suggested . I would think my main problem is gluing plugs to already established rock. But Often it feels strong but let's go after a while?
__________________
150 gallon reef mostly softies/lps. 50 gal sump with bubble magnus skimmer/ Led fuge light/refugium/ 1200 return and tunze powerheads. Dual pharoah main tank led.4 pump dosser. 550 gallon stingray tank water drip system 150 bowfront. 75 turtle tank, many others |
#6
|
|||||
|
|||||
![]() Sounds like your glue is no good I have glued down my entire sps reef with the ecotech crazy glue works great in the water.
|
#7
|
||||
|
||||
![]() Yeah. The crazy glue advanced resists water me thinks. But I assume that's what is meant by "advanced".
The Boston Aqua stuff works too, but the ecotech is reliable. Sent from my iPhone using Tapatalk |
#8
|
|||||
|
|||||
![]() I just use the lepage ultra gel from homedepot and epoxy. the epoxy gives it some hold while the glue sets, and lets it squish into holes in the rock.
|
#9
|
|||||
|
|||||
![]() I had the same problem until I started using a nail brush to scrub the LR
Once scrubbed, the glue stays stuck - enough so that I have to pry it off with a screwdriver |
#10
|
|||||
|
|||||
![]() Here's a trick I use when using glue. Put a blob of glue on the plug and then put the plug under water for a second or two. Then pull it out and put a little more glue on top. When you go to attach it to the rock don't just push it in place. Twist the plug and scrape it around on the rock a little till it really sticks. The problem with most crazy glues ( Ecotech excluded cause ive never tried it) is that as soon as you put it under water the glue forms a skin around it that isnt sticky at all. So scraping it against the rocks pops the bubble of glue and sticks much better.
|