![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||||
|
|||||
![]() I have yet another question for you Canreefers........
My 120-gallon tank is made from 9mm glass and has no top trim, currently, so I will definitely add a eurobrace. I am also considering a center brace to make the addition of tops easier. Must I use 9mm bracing too? I have an old 50 gallon that I can tear down but I know that 9mm can be tricky to cut. The fact that it is "old" glass makes it that much more difficult. Would I get away with 1/4" bracing? I have plenty of clean, 1/4" glass and could easily double up the braces to, in essence, have 1/2" supports. Your thoughts? |
#2
|
|||||
|
|||||
![]() If it were me I would go with 9mm for the euro-bracing. At the center of your span there will be significant pressure to bow and the thicker the brace the better you will sleep at night. You should be able to get a glass company to cut it for you and if you go with a 3" brace you are not looking at that much square footage.
__________________
210 Gallon slowly gaining population. Foxface, Naso, Coral Beauty, 2 Clowns, 2 Chromis, Orange Anthias, and Striped Goby. |
#3
|
|||||
|
|||||
![]() 6mm will not cut it Brad, go with the 10 mm just to be on the safe side of caution. You will not like the look of doubled up 6mm & if you go to 10mm you will not need a center brace.
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build |
#4
|
|||||
|
|||||
![]() Any suggestions on where to order glass from?
There are certain tank manufacturers in Alberta that I simply refuse to deal with. |
#5
|
|||||
|
|||||
![]() You can got to any glass shop for the euro brace pieces, I got some cut for my 116 gal from Lydens Glass in Red Deer.
__________________
Feed the bear goodies, make a new friend, don't feed the bear............... 8' - 165gal Reef DIY LED's Build 2012 Nano Contest Winner Febuary 2013 POTM Winner 300 gal + 60 gal Complete DIY Build |
#6
|
|||||
|
|||||
![]() Alright, I took a closer look at the tank. The sides are 9mm glass while the front, back and bottom are 12mm.
Inside measurements are 47 5/16"L and 23 1/16" width. For those that have done their own bracing, how big of a gap do you leave for your silicone bead? I am thinking of running the length of the front and back level with the panes and then putting cross braces on top of the side panes and front/back euro. Sound about right? |
![]() |
Thread Tools | |
Display Modes | |
|
|