![]() |
|
Portal | PhotoPost Gallery | Register | Blogs | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||||
|
|||||
![]() So i have this ehiem 1260 that is on one of my skimmers. I plugged it in today and noticed its making alot of noise. Impeller needle things seem to be broken
How can i tell if the impeller is only thing broken? When I put in the impeller, it doesnt sit the in middle, it keeps touching one of the sides. |
#2
|
|||||
|
|||||
![]() from here the pic is really blurry , but the impellar is shot and its cracked from what i see.
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. |
#3
|
|||||
|
|||||
![]() how do i know its the impeller? if i plug the pump in by it self, its queit but i can tell something is going on.
The impeller isnt cracked, well the shaft isnt. The plast part around the shaft where the needle wheel stuff is, is cracked. I was going to mesh mod it but its making alot of noise without the top part which is cracked, removed. |
#4
|
|||||
|
|||||
![]() here are two more pics of it without the plastic needle stuff on it
![]() ![]() |
#5
|
||||
|
||||
![]() You mesh/needle wheel is broken. Which will cause an imbalance when it spins, producing a lot of vibration and noise.
Also, those metal washers I see, hope they are high quality stainless or they will eventually rush and release copper into your system. I would get them out to be safe. |
#6
|
|||||
|
|||||
![]() alright, well lucky me i have two 1260s, one was running my chiller. I pulled it out, swaped the shafts and its quiet. I guess the shaft thing needs replacing but the motor is fine.
|
#7
|
||||
|
||||
![]() Quote:
But I would contact the company that made your skimmer and ask about the mesh wheel. It just doesn't look right missing a big chunk of the wheel. |
#8
|
|||||
|
|||||
![]() is the shaft the magnet part or the ceramic looking skinng thing that goes down through the magnet?
the magnet part is the one that is broken it seems. I switched out the ceramic thing and it didnt make a difference its an H&S skimmer, do they have mesh wheel? if i gota buy a new needle wheel then ill just keep it needle instead of mesh. is there ehiem mesh wheel pre made somewhere? |
#9
|
|||||
|
|||||
![]() this is what im going to buy
http://www.finsreef.com/xcart/produc...cat=286&page=1 |
![]() |
Thread Tools | |
Display Modes | |
|
|