Beckett Skimmer

[Richer]

I've been researching beckett designs for a little while, but there is still a few things I'm not quite sure about.

Here's what I have in mind:



Its a rough picture, I haven't yet decided on the height or width of the tubes yet, but thats more or less what I want.

Is the injector housing position ok? Too high? too low?
I'm going to be attaching a elbow (pointing downwards) to the output. Is the baffle position alright? or am I going to end up pumping a whole lot of bubbles into the tank?

Any general advice on height? This is going to run on a 30 gallon tank with a 15 gallon sump with two clowns and an algae blenny and a few corals here and there.

Thanks for the help,
-Richer