Quote:
Originally Posted by Bugger
Hi Elliot!
What setting are you using for your vectra?
How high do you have it turned on to. Is heat an issue?
I want to use two vectra in my system tied to two mocean spray devices but I am worried about heat.
Do you use two drain lines as your sump drain or just one.
I want an XMN device to surge my vortec pumps every fifteen minutes for maybe two minutes or so
|
I was worried about heat too, but it only uses 80w on max output, and as I have it set, it only uses around 52w. So it's more efficient than the Eheim 1262 I had. Heat is not an issue at all.
When you calibrate the pump, it sets itself up within the flow capacity of your system and then gives you a percentage range within that calibration setting to use. So you could use it on a 20 gallon tank, or a 200 gallon tank. Its incredible, and you have a lot of control over the calibration, so you can really set it up any way you like (flow/power wise).
I have a beananimal drain system, so my 1 x 1" drain line at full siphon can handle over 3,400 GPH, but I run it at a lot less than that to maximize skimmer efficiency and to make the system absolutely, hear a pin drop, silent.
