View Single Post
  #11  
Old 01-15-2016, 06:03 AM
iamfrontosa iamfrontosa is offline
Member
 
Join Date: Aug 2013
Location: Calgary
Posts: 181
iamfrontosa is on a distinguished road
Default

Hi Leanne,
I am with Mark (maron6977) on this one. Same way I set mine up.
My feed water from maxi jet 1200 is very slow. 50ml/min is the reading from my calcium's reactor integrated flow meter. I am not sure what that translated into 'drips per min.'
Maybe try tuning down your feed water, and see if there's still a leak. Excess pressure can cause leakage. My particular calcium reactor will cause a leak where the pH probe goes if too much pressure from feed water. It is built that way.
Just don't turn on your co2 until you are happy with the flow rate.

Last edited by iamfrontosa; 01-15-2016 at 06:05 AM.
Reply With Quote