Quote:
Originally Posted by Bblinks
5 cups of mag chloride and 3 cups of mag sulfate to produce a gallon of mag mix, the pre-bagged mix is for 2 part. you are suppose to mix up 20 ounces and dose it at the end of your calcium and alkalinity gallon mix and not to raise your level.
To raise your wc just mix the 5 and 3 and use the brs calculator for the mag mix and that should do it.
|
So I shouldn't use part C (mag) to raise mag in NSW, instead I should go buy the bulk Chloride and Sulfate, mix 5:3 and follow the BRS calculator for mag mix? I don't think the Shlobster mag mix is the same ratio as that but i will check the label when I get home
Just thinking I should add mag before going in the tank instead of after like the instructions say, keep reading if you wanna see why this would be a problem
As per the Shlobster instructions adding part A and part B are quite easy to understand. My tank has 8 gallons of water and no sump. It says to add 2.5ml of A+B per 10 gallons of water, I assuming this is per day, so I will just lower this to 2ml. So 2ml per 8 gallons, Not a math whiz but that sounds about right..
At this rate it will take me 2000 days (5 years 173.5 days) to use 1 gallon of each mix
Instructions:
Quote:
|
When you have consumed 1 gallon of both parts A & B, you need to add 20oz of Part C (Magnesium). You can add this all at once (slowly, to an area of high flow), or in smaller increments over time, say 5oz each day for 4 days, just remember to dose 20oz of Magnesium for every gallon of each of A & B added
|
So after 5 1/2 years of dosing a gallon of each A+B, now I'm supposed to add 20 ounces (.59 litres) of part C.
It would be nice having instructions pertaining to this product line in particular.
EX: add 10 ml of part C solution to 10 gallons it will raise Mag by 10ppm
Kind of like how Brightwell has instructions on their label? I just don't trust Brightwells math, they have a math error on the Magnesion P label which Ive been talking with one of their scientists to fix