View Single Post
  #24  
Old 06-01-2014, 05:38 PM
tlhood's Avatar
tlhood tlhood is offline
Member
 
Join Date: Nov 2013
Location: Calgary
Posts: 473
tlhood is on a distinguished road
Default

After 9 hours, the hood is put back together and the lights/controller appear to be working well.

Some critiques about the kit:

1)Missing parts
2)No instructions regarding the assembly of ALL the LDD drivers, fans, new power supply and storm controller. The ones provided are for the larger drivers using the timer and rsm power supply, or just connecting the controller to the power supply and drivers. Fans were all willy nilly.
3) the new power supply doesn't fit in the hood
4)heatsink holes were too small for the zip ties
5) there were 4 plastic sticky out things in the hood that interfered with closing after the zip ties were used to attach the heatsink to the reflector thingy. The 4 sticky out things were where the screws used to be in order to attach the reflector to the hood.


Solutions:
1) left the last two LEDs (1 UV and 1 White) unhooked until Rapid LED gets me the missing wires.
2) Relied on my grade 5 understanding of circuits to wire everything together. I ended up ripping out the timer and the driver, drilled a hole through the bottom of the timer compartment, and threaded the jumpers and fan wires down. I had to extend the fan wires with the bulk wires. All wires now come out where the main plug for the RSM comes out. Drivers are wired into the new power supply and the controller. Fans are wired directly into the power supply.
3)Power supply is external. As the wires were too short, it is on a stand beside the DT.
4)Drilled bigger holes.
5) drilled into the sticky out thingies to make them thin enough to snap off with pliers.
Reply With Quote