[jon.smolders]

Some aquascaping photos. Cut up a fiberglass driveway marker for the rod, and fit them into holes I drilled with a masonry bit:








For the supports underneath the rock I cut and notched 3/4" PVC pipe, then cut eggcrate to fit rock footprint and siliconed it to the pieces of pipe. Hopefully this will allow a bit of flow under the rock and prevent detritus buildup.





And final aquascape... I might trim up that middle PVC/eggcrate support so its not as visible. I may also make some kind of support for the smaller rocks on the right hand side. Haven't decided yet.