Hello all, this is my first post on the board and I am asking for some advice on my skimmer....
The skimmer was purchased off ebay for $30.00, as you can see it is well made and works fantastic. I am feeding the skimmer w/a Rio 800 powerhead and feeding the tank w/a Mag 250 pump. I am currently using a ball valve on the inlet to control the level of water inside the skimmer. My dilemma is that I am constantly messin w/the ball valve because as the water lever in the tank go's up and down so does the level inside the skimmer. How do I make the level in the skimmer consistant?
Also, I would be open to any other suggestions in regards to the design.
Thanks all!!