Quote:
Originally Posted by nrosdal
Thanks all for the kind words. I am quite happy with how it came out.
No, the bearing for the most part is stationary once against the material and even if it spins a bit i have not had any issues with scuffs on material as there is quite a bit of sanding and polishing after trimming anyway.
|
Nick,
Do you run the router at the slowest speed to keep the router bit from getting too hot from melting the polycarbonate?
I've built a few things here and there for my setup but nothing that nice.
I typically run my polycarbonate through the table saw to get a finished edge therefore leaving my with 1 edge to glue with MC.
I'm going to have to try your approach.
Once again, you're an Artisan with polycarbonate!