Good Point, the ceramic rings and SeaChem Matrix is gone - and sump cleaned. Before I run the coil I'll test nitrates.... Dont worry.
Well, back to the denitrate coil. Yesterday I finished all the plumbing for the "IN" side of it. Not much working room and things in there are tight. Here is a before pic.
http://i101.photobucket.com/albums/m...pscbc849a8.jpg
I had to use a 90degree connecter to get the bits together, but there shouldnt be 'much' water moving through this thing so... it should be good. I might hate myself for using the internal barbed connecter (even narrower and more flow restriction) much like the other 90 connecter at the bottom. Maybe I should have used the double female quick connect push connector. We will see with time.
Here is an after shot & you can see some silicone - GE1 (windows/doors) just enough to keep the tubes inside from moving or shifting.
http://i101.photobucket.com/albums/m...ps8b63cf5a.jpg
I finished work on the top cap BUT dropped it and now I am re-JB Welding it. I think it would have been fine without more JB but I'll add just a bit more - never hurts. Pics on the next post.
All thats left is to glue on the top cap, add in BIO BALLS (I'm still searching for some - Hint Hint Hint) & screw on the bottem cover.
It will need 2 hoses hooked up and a week or 2 to cycle. Then we will see.