Big night last night for the set up of my large aquarium. Got most of it pieced back together, still a couple small items outstanding. The following was assembled last night:
- sump installed and hoses, pumps, overflow and return set up
- small cracks along the bottom of the sump where the main bulkhead meets the floor. I siliconed them inside the sump, I hope they won't leak...
- UV sterilizer installed on return from sump
- Dual media reactor and pump installed
- Protein skimmer installed (HOB)
- Heater and controller installed
- ATO unit set in position to be configured when system is wet
- MP40 unit installed, still need to position and configure the controller
Not bad for a guy that went home from work sick earlier in the day. For some reason I am taking a long time to get better...
Remaining items:
- hang light fixture and solder/install moonlight LEDs
- configure ATO when system is wet
- position and install MP40 controller
- configure protein skimmer when system is wet
- rock work! (this could take forever...)
I haven't touched the nano-cube set up yet, it's been a big job getting the large tank set up again. Will take pictures of the set up tonight when I get home.