I haven't started work on the sump yet, wanted to make sure that this overflow is solid and so far I'm really impressed with it's startup. Also I've already cut those pieces of Acrylic so might as well use those. That being said, how much is glass to have cut for a sump?
So added the next step to this test setup.
This is the part where the water drops in and the siphon is kept in check without draining the whole tank. This mock up isn't cut very well, going to have to figure out the best way to cut ABS plastic. I like the black because once it's in the tank it looks almost like any other overflow (minus the tuck tape at the bottom, that will be sealed properly). Also had to add rocks to the bottom to weigh it down. I'll probably just use sand in my main tank. Just to make sure it doesn't float up. Or any other suggestions?
You thought it was chaos before. Now it's just funny. I didn't want to buy extra pieces just for this test setup so this is what I came up with. There was a lot of wind lately so I couldn't have the water just fall into the bucket, it just blows outside the bucket then by the end of the night the pump is running dry.
