Quote:
Originally Posted by dave@conceptaquatics
Hi Trevor
Yes we had a run of tanks that had this problem  didn't realize at the time the surface tension of water would back up with those size cuts! we figure it would look cleaner but never work out that way
give Denny a call at the shop at 5873237360 and i will have a new panel made up and overnight it out to you
thanks Dave |
Quote:
Originally Posted by denny@conceptaquatics
absolutely , we had several tanks that we did this too , like dave said the idea was to make it a cleaner look but for some of the large tanks it couldnt handle it.
right now we go with a machined 1/4" notches for all tanks.
i have spoken with trevor on the phone and we are in the works of getting this resolved quickly for him.
in the mean time trevor just break off the current teeth you have this will allow you to finish up with your plumbing, i will have new acrylic out to you immediately 
cheers buddy
denny
concept aquatics |
Hey guys....Well I certainly did like the look of the smaller gaps, I never even thought of this being a possible issue when I seen them after the tank was built. So I have broke off every second tooth and the drains flow flawlessly did my emergency drain test by closing the gate valve on the main and the unrestricted 1.5" drain is a BEAST!
Thank You for your timely response in helping me rectify this issue!