[sphelps]

From manual:

The setting Use digital powerbars has only an effect on S1-S4! All other connections for
powerbars (e.g. S5 - S8) are furthermore only suited for common powerbars, these connections also
can’t be set to digital.
If the option Use digital powerbars has been activated, then with S1-S4 you can’t control a
common powerbar.
A mixed operation of digital sockets (at S1-S4) and common sockets (at the other powerbar sockets,
e.g. S5 - S8) is possible.
If the switching state or the numbering shall be set, only one single digital powerbar resp. dosing
pump unitmay be connected. If several devices would be connected during the programming, then
all would overtake the new programming!
The numbering of digital powerbars and dosing pump units is freely selectable (see Set
numbering). In contrast to that, the numbering of common powerbars is predefined by the fact at
which socket they are connected. Sockets of one powerbar connected to S5 - S8 have e.g. always
the numbering 5 to 8. Here you have to keep in mind that no double assignment of numbers occurs!
The set numbering and output states are permanently stored in the digital powerbar and so are also
kept when it is not connected to the power supply voltage.