use a threaded male adapter on the inside of the bulkhead to assist in removing the outside nut....should help stop the spinning....assuming your bulkhead is double threaded...
i would try the rubber gasket on the inside if only one came with the bulkhead fitting
Quote:
Originally Posted by duncangweller
I believe it is a 1 3/4 hole. When I had the tank set up in my old place there was a minor leak around the bulkhead which stopped after a few days. Since I have moved o can't get the thing to stop leaking.
Also, now that I have tried a gasket on both sides I can't get the bloody nut off the outside.......aaaaaaarrrggggghhhhhh!
Sent from my Nexus 7 using Tapatalk 2
|