Quote:
Originally Posted by Titus99
Just buy chance have u put a multi meter on your tank to check for stray current with pumps on and off
|
I haven't but wouldn't that bother everything when everything is running anyways?
Quote:
Originally Posted by monocus
what size tank do you have and how many fish.my algae stays on my screen when i remove it for cleaning so i can't see what you would be knocking into your tank.even if you bent your screen around-water is always running down the screen and would be constantly adding anything bad into your tank
|
That's exactly what I would assume too. I have a 180G with a 40G sump and I have 22 fish but half of them are smaller schooling fish so they don't have huge appetites.
Quote:
Originally Posted by tang daddy
If it is infact your ATS, then perhaps you could in future have a bucket ready with the water that's returning back into your sump from your ATS go into the bucket for 1/2 a minute. What ever toxins that were released while removing the algae mesh would be caught on the return line in the bucket then also flushing the remaining water and remnants in the ATS and hose out.
Monocus was over when I cleaned my ATS mesh last week, because I run it in a 5g the whole bottom of the tank has algae and detritus settling from the low flow, I use my hand to scrape the bottom leaving loose bits behind, some of these bits make back into the sump and return to display when I turn my ATS back online. I've never had a problem losing fish although my return pump constantly runs, my ATS is fed from the chiller pump which is T'ed off and separate from the system.
|
That's my plan from now on. To be absolutely sure that any water discharged after the scrubber is taken offline is collected in a bucket. Right now I have it T'd off my return pump but I use a shutoff valve to stop the flow.
I'm pretty scared to even turn it back online again to be honest. I modified an aquafuge with pvc pipe and the mesh screen is the exact screen recommended by algaescrubbers.net (#7 from Michaels) so I can't see it being a problem with the setup releasing toxins into the water. The problem is my bioload is pretty high to not have it working too. I skim with a Bubble King 250, run carbon, biopellets and dose Prodibio Biodigest to keep the parameters in check and so far it's worked great given the number of fish I have. I also do 40G water changes every two weeks.