Ok, I picked up this stuff the other day (AquaStik Epoxy Putty by Two Little Fishies) I followed the directions to a T.... cut a piece off, kneaded it until it was soft (chewed gum consistency, lol) and put it on the piece of coral I wanted to stick down (to the back glass of my tank) and.... waited. I let it go a few minutes later and..... it didn't stick. I thought "Ok, maybe I didn't hold it long enough." So I held it a bit longer...... it stuck! For about 2 minutes then fell off again. This time when I touched the putty it was almost rock hard. I pealed it of and threw it out.
So my question is... how do I make this stuff stick? Is there something I'm missing? Am I doing something wrong? Or did I listen to the wrong person and get the wrong stuff?! LOL
thanks in advance of any helpful tips or tricks! (or advice!)
Dawn