Been a while, lots of skiing so not much work on the LED project, but I did manage to get a little more done. I've decided to go with a third rail down the center. Probably have some funky coloured night lights & one or two day supplement arrays on that. Maybe even a green or red. The two outer rails will do the bulk of the work. I've cobbled them together using two pieces of plywood to experiment with spacing & get an idea of what kind of spread the currently planned mix of LEDs will give.
I've ordered 10 more heatsinks with fans & 10 Blue arrays to see how they will work with the current bunch of Royal Blues & 10,000K. Still need a bunch of 5 to 10 watt resistors in the 1.5 to 3.3 ohm range to tune each LED array to the proper running voltage/current. As it sits right now with 17 LEDs, heatsinks, aluminum & plywood, the unit weighs in at 1.8 Kg, that's 4 lbs. Nice & light. Current plan will be to have 9 LED arrays on the two outer rails & maybe 4 to 6 on the center rail. Also need to add the weight of resistors, more wire, project boxes to wire the whole shebang etc. Might also add some plywood skirting to make some sort of open hood in order to minimize light spill & hide the aluminum. With any luck I'll be able to keep it under 10 lbs.
Here it is. Spacing between LEDs on each rail will be approx 4.5 inches. Spacing of LEDs between rails is around 5 inches. I plan to rotate the outer rails slightly inwards. No optics, I'll play with height above water to find a good compromise between spread & light output.
End view. The plywood will allow me to drill holes easily & reposition the rails if necessary. The wingnuts provide quick adjustment of the inward tilt of the outer rails.
Another view to better illustrate the tilt on the outer rails.
